Here are the steps required to mount a Stonehouse Custom Magnetic Dry Erase Board. Follow these 8 steps to ensure your board is mounted properly.
If you have any questions, contact our expert staff by using the
chat & click-to-call features to the right, or just give us a call
at (800) 525-0456.
For tips cleaning up your dry erase board, check out our series on How To Erase A Permanent Mistake.
Tools Required: - Screwdriver or Electric Drill/Screw Gun
- Pencil
- Level
- Measuring Tape
- Stud-Finder (optional but recommended)
|
- Inspect the mounting materials that are included with your board.
|
| Brushed Aluminum Frame Materials | Wooden Frame Mounting Materials |
 |  |
Every standard board is shipped with a pack of mounting materials, which includes:
- (4) Self-Tapping Screws (Aluminum Frame) or (4) Wood Screws (Wood Frame)
- (4) Mounting Brackets
- 'Dry Erase Board Cleaning' decal with removable adhesive
|
- Determine where you would like the board installed. Space the bottom brackets 2"- 3" from each side of the board. Ensure the brackets are level on the wall.
|
- Screw and secure bottom mounting brackets into the wall stud or use a wall anchor.
Please take note that screws to mount brackets to wall and/or anchor are not included in the mounting package.
|
- Set the Dry Erase Board onto secure bottom brackets, and slide the top brackets on top of board until they are resting 2"-3" from each side.
Use a pencil to mark the top edge of each bracket.
|
- Remove the dry erase board. Using the pencil marks from step 4, tighten and secure screws for the top mounting brackets.
|
- Replace the dry erase board between the mounted brackets.
|
- Using the included self-tapping screws or wood screws, attach each bracket to the top and bottom of the board.
|
- Install the 'Dry Erase Board Cleaning' decal with removable adhesive in a place of your choosing.
|
Here's an example of how your board should look when it's finished!
 |
1-800-525-0456 Email
